Description
If your implements are swaying like a pendulum when you lift them or drifting off center during field work, it’s time for a new stabilizer arm. This insurance policy against expensive accidents keeps your bush hog from swinging into trees when you’re clearing fence rows, prevents your tiller from walking sideways in hard ground, and stops your blade from drifting when you’re maintaining driveways. When stabilizers fail, even simple tasks become frustrating and potentially dangerous.
What You’re Getting
- One piece forged ends with no welds to break – built to handle the constant stress of field work
- Adjusts from 27 1/2 inches to 35 inches for versatile implement control
- Standard 7/8 inch pin holes and threads fit most Category 1 three-point hitches
- Works as either right hand or left hand application depending on your setup
Built for Real Farm Work
This adjustable stabilizer eliminates that dangerous side-to-side movement of your three-point implements. It’s designed for Category 1 tractors running everything from rotary cutters and tillers to box blades and cultivators. The heavy-duty construction handles the constant loading and unloading that comes with normal implement operation.
Made to Last
Installation is straightforward – remove your bent or worn stabilizer by unthreading both ends, then install the new one. Start with the turnbuckle centered for maximum adjustment range both ways. The forged ends eliminate the weak spots that cause cheaper stabilizers to snap under load.
Good to Know
For rigid control like box blades and cultivators, tighten until movement is eliminated but not so tight that it binds. The beauty of the turnbuckle design is on-the-fly adjustment – if your disc harrow starts wandering on a side hill, a few turns brings it back in line. Keep the threads clean and lightly oiled, check for bent components after striking obstacles, and ensure the pins aren’t wearing oval holes in your mounting points.
Reviews
There are no reviews yet.