Description
When your hydraulic cylinder starts getting sloppy at the end of the rod or you can’t get the pin out anymore, it’s time to replace that rod clevis. This little fitting is what connects your cylinder to whatever it’s pushing or pulling, so when it wears out, you’ll know it—things get loose, crooked, or just plain ornery to operate.
What You’re Getting
- Built by Cross to handle heavy-duty hydraulic work on 2 inch and 2-1/2 inch bore cylinders
- Precision threads that screw right onto your cylinder rod without fighting
- Pin hole sized for standard 1 inch diameter clevis pins that come with most cylinder installations
- Compact design that won’t add unnecessary length to your cylinder setup
Built for Real Farm Work
This clevis works with Cross hydraulic cylinders commonly found on loaders, implements, and attachments across the farm. Whether you’re running a front-end loader, operating a three-point implement, or working with hydraulic attachments, this is the connection point that takes all the stress and strain of the job.
Made to Last
Cross builds these clevises to handle the constant loading and unloading that comes with hydraulic work. The threads are cut deep and true, and the pin hole is sized to minimize wear while keeping a snug fit. It’s designed to take the punishment of daily farm operations without loosening up or cracking.
Good to Know
Make sure to clean the threads on your cylinder rod before installing the new clevis—any dirt or old thread locker will make installation harder than it needs to be. A little anti-seize on the threads isn’t a bad idea either, especially if you might need to remove it again down the road.
Reviews
There are no reviews yet.