Description
When your swinging drawbar gets loose and starts rattling around or won’t stay aligned, it’s usually this little pin and spring clip causing the headache. This kit includes both the pin and spring clip that secure your Ford tractor’s swinging drawbar assembly, keeping everything tight and properly positioned when you’re pulling implements through the field. A loose drawbar isn’t just annoying—it can cause uneven pulling and put stress on your three-point hitch.
What You’re Getting
- Pin and spring clip work together to eliminate drawbar play and rattling
- Direct replacement parts that match the original Ford specifications
- TISCO brand quality that holds up to the constant stress of field work
- Complete kit means you get everything needed for a proper repair
Built for Real Farm Work
This kit fits Ford 2000, 3000, and 4000 series tractors from 1965 and up, plus earlier models from 1953 to 1964 including NAA, Jubilee, 501, 600, 700, 800, and 900 series that use the swinging drawbar setup. These are the utility and row-crop tractors that handle everything from cultivation and planting to brush hogging and loader work—machines that see daily use and need their drawbars to stay put.
Made to Last
The pin is machined to the right tolerance for a snug fit without binding, while the spring clip provides the holding force to keep everything in place. Both pieces are built to handle the constant flexing and loading that comes with pulling implements through rough ground and tight turns.
Good to Know
Installation is straightforward—remove the old worn parts and install the new pin and clip. The spring clip slides over the pin end to lock everything in position. If the old pin is stuck, a few taps with a drift punch usually does the trick. Keep the area clean during installation to prevent dirt from getting into the pivot points.
Reviews
There are no reviews yet.