Description
When you’re cutting thick hay or tough crop stubble, nothing beats the sharp, aggressive cutting action of overlap sections on your sickle mower. These sections give you the extra bite you need when standard sections just won’t slice through cleanly. This complete kit gets you set up with everything you need for both left and right sickles, so you can tackle the whole width of your header without making multiple trips to town.
What You’re Getting
- Top serrated sections with fine tooth design for clean, precise cutting through dense crops
- Three smooth sections paired with two saw tooth sections for the right balance of cutting power
- Complete rivet set included—no need to hunt for the right fasteners
- Ready-to-install kit covers both sides of your sickle bar in one purchase
- Plated finish resists rust and corrosion even in tough field conditions
Built for Real Farm Work
This kit fits Hesston and Case IH sickle bar mowers that run the riveted knife system. Whether you’re cutting alfalfa, clover, or heavy grass hay, these sections handle the workload. The 2.063-inch hole spacing and 3-1/4-inch length make them a direct match for your original equipment, so installation goes smooth and the cut quality stays consistent across your entire cutting width.
Made to Last
KONDEX builds these sections to handle the constant vibration and impact that comes with sickle mowing. The plated finish adds protection against moisture and field debris, while the precise serration pattern keeps its edge longer than generic aftermarket sections. You’ll get more acres cut before needing to touch up or replace.
Good to Know
Installing overlap sections requires removing the old ones and driving out the worn rivets—a job that goes easier with a rivet set and punch. Take your time lining up the sections before setting the new rivets to ensure smooth operation. If your knife bar has been running rough, this is a good time to check for any bent or worn knife head components too.
Reviews
There are no reviews yet.