Implement Yoke for PTO Series 12 Drivelines – 1-1/4 Inch Round Bore with Double Keyway

Description

When your PTO yoke starts showing wear or damage, don’t wait until it leaves you stranded in the middle of a critical job. A worn or damaged PTO yoke doesn’t just cause annoying vibrations – it’s a ticking time bomb that can destroy expensive drivelines or worse, become a deadly projectile when it finally lets go. This Weasler Series 12 implement yoke gives you the solid, reliable connection your driveline needs to keep power flowing smoothly from tractor to implement.

What You’re Getting

• Series 12 design handles medium-duty applications without the bulk of heavier series
• 1-1/4 inch round bore with double keyway prevents slippage under load
• 3-1/2 inch center-to-end dimension for proper driveline geometry
• 1-1/16 inch bearing caps provide robust U-joint support
• Precision-machined bore maintains tight tolerances for years of service

Built for Real Farm Work

This Series 12 yoke fits right in the sweet spot for implements that need more strength than a Series 6 but don’t require the beef of a Series 14 or 35. You’ll find this size on rotary cutters, hay rakes, tedders, and other medium-horsepower implements typically run on 30-60 horsepower tractors. The double keyway design ensures positive drive engagement without the slop that causes premature wear.

Made to Last

Weasler doesn’t mess around – their yokes are forged tough and machined to tight tolerances. The bearing surfaces are precision-ground to ensure smooth U-joint operation, while the bore is cut accurately so your implement shaft slides in snug without excessive play. This isn’t a hardware store part that’ll fail when you need it most – it’s built to handle the constant speed changes and angles that come with real field work.

Good to Know

Make sure your implement shaft is exactly 1-1/4 inch diameter with matching double keyways before ordering. The shaft should slide in smoothly without forcing, and you’ll need proper-length keys to fill both keyways completely. Check that assembled driveline length allows full range of motion without bottoming out or pulling apart. A quick tip: always grease U-joints after installation and check for any binding through the full range of motion.