Description

If your PTO guard shield is getting sloppy and rattling around during operation, those worn nylon bearings aren’t just annoying—they’re compromising the protection that shield provides. A shield that wobbles or binds up can’t do its job properly, and in a worst-case scenario, it might even interfere with PTO operation when you need it most.

What You’re Getting

Complete bearing set for both inner and outer shield positions on Series 8 and 9 guards
Durable nylon construction that runs smooth and quiet while providing long service life
Precise dimensions that restore proper shield operation without binding or excessive play
Heavy-duty 450 guard type rating built to handle the larger implements these series typically run

Built for Heavy-Duty Work

This kit is designed for the larger Bondioli Series 8 and 9 PTO systems you’ll find on bigger tractors running substantial implements like large bush hogs, heavy balers, and commercial-grade mowers. These guards need to spin freely while protecting operators from high-horsepower PTO shafts that can cause serious injury.

Made to Last

Nylon bearings are the right choice for PTO guards because they run without lubrication, resist dirt and debris better than metal bearings, and won’t seize up from corrosion. These Weasler bearings are manufactured to tight tolerances so your shield spins freely without the slop that causes noise and premature wear.

Installation Notes

Installation is straightforward—just remove the old bearings and press in the new ones. Clean out any dirt or debris from the bearing bores first, and check that the shield itself isn’t cracked or damaged. While you’re at it, make sure the shield spins freely and completely covers the PTO shaft during operation.