Description

When you’ve got high-horsepower equipment running PTO-driven implements like balers, combines, or feed mixers, a single belt just doesn’t cut it. This double banded cogged belt gives you the extra grip and power transfer you need when there’s no room for slipping. The two belts work together to handle those heavy loads while the cogged design grabs the pulley grooves for maximum efficiency.

What You’re Getting

Double band construction spreads the load across two belts for longer life and better power transfer
Cogged design increases surface contact with pulleys for superior grip and less slippage
5/8-inch width and 70-inch length fits a wide range of agricultural equipment
Standard polyester construction handles the heat and stress of continuous operation
Direct replacement for worn or stretched belt sets

Built for Real Farm Work

This belt setup is commonly found on equipment that demands serious power—think round balers, large square balers, combine headers, and other heavy-duty implements. The double band design is especially useful when you’re running equipment at full capacity during harvest or when conditions are tough and you can’t afford breakdowns.

Made to Last

The cogged construction and double band design work together to distribute stress and heat better than conventional smooth belts. This means less stretching over time and more consistent performance when you’re pushing your equipment hard during those long days in the field.

Installation Notes

Always replace belts in sets if you’re running multiple belts on the same system—mixing old and new belts creates uneven wear. Check your belt tension after the first few hours of operation, as new belts will settle in and may need a slight adjustment to maintain proper grip. Before installing, check your pulleys for wear or damage that could cause premature belt failure.