Description

When your hydraulic cylinder starts weeping oil or moving sluggishly, worn seals are usually the culprit. This seal repair kit gives you everything you need to rebuild that cylinder back to full working condition without the expense of a complete replacement. No more oil puddles under your tractor or sluggish hydraulic response when there’s work to do.

What You’re Getting

Complete set of seals, O-rings, and wiper seals designed specifically for your cylinder size
Premium seal materials that handle the pressure cycling and temperature swings of farm work
Precision-manufactured components that fit properly without excessive squeeze or leakage
Direct replacement seals – no modifications or adapters needed

Built for Real Farm Work

This kit fits Cross and Hydroline hydraulic cylinders with 3-inch bore and 1-1/4-inch rod, a size commonly found on mid-sized tractors and implements. Whether you’re running a front-end loader, operating three-point implements, or powering hydraulic attachments, these cylinders handle the steady work that farming demands.

Made to Last

Farm hydraulic systems work hard in dusty, dirty conditions with constant pressure changes and temperature swings. These seal materials resist hardening and cracking from age and heat cycles while maintaining the flexibility needed for proper sealing. Each component is manufactured to exact tolerances for reliable performance season after season.

Installation Notes

Cylinder rebuilding requires cleanliness above all else – any contamination causes rapid seal failure. Lubricate with clean hydraulic fluid during assembly and take your time with installation. After rebuilding, cycle slowly at first to seat seals properly, and replace all seals in the kit even if some look okay since they’ve all seen the same service hours.