Description

When you’re fixing equipment and need to drive out stubborn roll pins or install new ones, the wrong tool can turn a simple job into a frustrating mess. This 5/64-inch roll pin punch from Mayhew gives you the precision you need to remove and install roll pins cleanly without damaging the surrounding parts or the pins themselves.

What You’re Getting

Precision-ground 5/64-inch tip that matches standard roll pin sizes perfectly
1-1/2 inch pilot length provides excellent control and reach into tight spaces
Black oxide finish resists corrosion and provides better grip for your hammer
3-1/4 inch overall length gives you the right balance of control and leverage
Heat-treated steel construction handles repeated hammer blows without mushrooming

Built for Real Shop Work

Roll pins show up everywhere on farm equipment—from securing PTO shafts and hydraulic fittings to holding linkage pins in place on cultivators and planters. This punch handles the most common 5/64-inch size you’ll find on tractors, implements, and shop equipment. Whether you’re rebuilding a hydraulic cylinder or replacing worn bushings, having the right size punch saves time and prevents damage.

Made to Last

Mayhew makes these punches from quality tool steel that’s properly heat-treated to take the punishment of shop work. The black oxide finish not only looks professional but also helps prevent rust when the tool gets stored in a damp toolbox or left on a workbench.

Good to Know

Always use a punch that’s slightly smaller than the pin you’re removing—this one’s perfect for standard 5/64-inch roll pins. Support the work piece properly and punch from the correct side if the pin has a taper. A few drops of penetrating oil on stubborn pins makes the job much easier.