Description

When you’re dealing with rotating shafts on your tractor or implement, there’s nothing quite as frustrating as a bearing that’s seized up or wobbling around loose. This greasable insert bearing with lock collar gives you a solid, reliable connection that’ll handle whatever your equipment dishes out. The wide inner ring design spreads the load better than narrow versions, which means it’ll last longer under heavy use.

What You’re Getting

15/16″ bore fits common shaft sizes found on many agricultural implements
52mm outer diameter works with standard pillow block housings and flanges
Lock collar design clamps tight to the shaft – no slipping or spinning
Greasable fitting lets you pump in fresh grease to keep things running smooth
Spherical outer race allows for slight misalignment without binding up

Built for Real Farm Work

This bearing fits right into the workhorses of your operation – disc harrows, cultivators, planters, and other implements where shafts need to spin freely but stay put. The 15/16″ bore size is common on gauge wheel assemblies, coulter units, and various drive components. Whether you’re working ground or planting, this bearing handles the dirt, vibration, and side loads that come with the territory.

Made to Last

Agricultural equipment bearings take a beating from dust, moisture, and constant vibration. This one’s built with quality materials and tight tolerances to handle those conditions. The greasable design means you can push out contaminants and keep fresh lubricant flowing to the rolling elements, extending bearing life significantly over sealed units.

Installation Notes

The lock collar makes installation straightforward – just slide it onto the shaft and tighten the collar to lock it in place. Make sure to pump grease into the fitting until you see it coming out the seals, then back off slightly. A good rule of thumb is to re-grease every 50 hours of operation or at the start of each season.