Repair Kit for Banjo 2-Inch Centrifugal Transfer Pumps with Buna Seals

Description

When your transfer pump starts losing prime or you notice cavitation sounds that weren’t there before, it’s usually time for new seals and gaskets. A pump that’s not holding pressure properly means wasted time when you’re trying to fill spray tanks, move liquid fertilizer, or transfer diesel fuel. This complete repair kit gets your Banjo centrifugal pump back to full performance with all the seals and components you need for a proper rebuild.

What You’re Getting

• Complete seal package including O-ring segments, body O-rings, and check valve components for thorough rebuild
• Buna rubber seals that resist chemicals commonly used in agricultural applications
• Direct replacement parts designed for new-style Banjo pumps from 1996 and newer
• All gaskets and O-rings needed to prevent leaks and maintain proper suction
• Quality components that restore original pump performance

Built for Real Farm Work

This repair kit fits standard 2-inch centrifugal transfer pumps commonly used around farms and ranches. These pumps handle everything from filling water tanks and transferring diesel fuel to moving liquid fertilizer and herbicide solutions. Whether it’s mounted on your spray rig, nurse tank, or portable pump setup, these seals keep fluids moving when you need them most.

Made to Last

Buna rubber construction means these seals handle the chemicals and temperature swings common in agricultural applications. The material resists swelling from petroleum products and degradation from herbicides and fertilizers, so you get reliable sealing performance season after season.

Installation Notes

This is designed for the new-style pumps from 1996 and up – check your pump to make sure it matches before ordering. This is a direct replacement that bolts into your existing pump housing. Check all gasket surfaces for damage and replace seals as needed during installation. A quick tip from the shop—mark the position of your old volute before removal to ensure proper alignment when installing the new one. Clean all surfaces thoroughly and use the right torque specs to prevent leaks without over-tightening.